Exabyte VXA-2, Руководство по эксплуатации продукта, Страница: 13 / 90

D
ECEMBER
2003 VXA-2
3
C
OMPONENTS
B
ACK
P
ANEL
C
OMPONENTS
– I
NTERNAL
D
RIVE
Figure 1-4 shows the back panel components of the internal SCSI drive.
Figure 1-5 shows the back panel components of the internal IDE/ATAPI drive.
For more information about using these components during installation, see
Chapter 2 .
Auxiliary Connector Used for tape drive diagnostics and to enable term
power (see page 10 ).
SCSI Connector (SCSI model only) Used to connect the tape drive to the SCSI
bus. This is a standard 68-pin wide, Ultra2 SCSI LVD connector. (See Table 7-4
for pin assignments.)
SCSI ID Jumper Block (SCSI model only) Used to set the SCSI ID.
Figure 1-4 Internal SCSI drive: back-panel components
Figure 1-5 Internal IDE/ATAPI drive: back-panel components
SCSI
Grounding
Grounding RF service Power
SCSI ID
Auxiliary
connector connector
tab
hole connector connector
jumper block
IDE/ATAPI
Grounding
Grounding
RF service Power
Auxiliary
connector connector tab
hole
connector connector
IDE/ATAPI configuration
jumper block