Design and function
Plasma welding
36
099-007021-EW501
29.07.2015
5.9.5
Select welding task
The welding task is selected using the buttons on the machine control on the welding machine.
Signal lights (LED) display the welding parameter selection.
The following plasma JOBs are pre-defined and may be selected in JOB manager:
• JOB 130 plasma, 2.4 mm needle, up to 150 A
• JOB 140 plasma, 4.0 mm needle, up to 300 A
• JOB 150 plasma, 3.2 mm needle, up to 250 A
Other JOBs can be added as follows "- See 5.14 Organising welding tasks (Mode "JOB Manager")
chapter".
It is only possible to change the basic welding parameters if:
No welding current is flowing and
The key switch (option) is set to position “1”.
Operating
element
Action
Result
Display
x x
Select JOB Manager mode
Press until the “VOLT”
signal light is on
2 sec.
Select JOB Manager mode
Select the required JOB number using the rotary
transducer (e.g. 150)
1 x
JOB loaded, machine switches back to Display
mode.
The JOB can be customised as required.
Current value and JOB
number displayed
Содержание Tetrix 150 Synergic Plasma
Страница 16: ...Machine description Front view 16 099 007021 EW501 29 07 2015 4 Machine description 4 1 Front view Figure 4 1...
Страница 18: ...Machine description Rear view 18 099 007021 EW501 29 07 2015 4 2 Rear view Figure 4 2...
Страница 32: ...Design and function Plasma welding 32 099 007021 EW501 29 07 2015 Figure 5 7...
Страница 109: ...Appendix B Overview of EWM branches 099 007021 EW501 29 07 2015 109 11 Appendix B 11 1 Overview of EWM branches...
