Design and function
TIG Synergic operating principle
099-007021-EW501
29.07.2015
55
5.11.9.6 Non-latched operation, version C
Figure 5-25
1st cycle
• Press torch trigger 1, the gas pre-flow time elapses.
• HF ignition pulses jump from the electrode to the workpiece, the arc ignites.
• Welding current flows and immediately adopts the ignition current value set (search arc at minimum
setting). HF is switched off.
2nd cycle
• Release torch trigger 1.
• The welding current increases in the set up-slope time to the main current AMP.
Pressing torch trigger 1 starts the slope (tS1) from main current AMP to secondary current
AMP%. Releasing the torch trigger starts the slope (tS2) from the secondary current AMP% back
to the main current AMP. This process can be repeated as often as required.
The welding process is ended by the arc interruption in the secondary current (removing the
torch from the workpiece until the arc is extinguished).
The slope times can be set- See 5.19 Machine configuration menu chapter.
This operating mode needs to be activated- See 5.19 Machine configuration menu chapter
section.
Содержание Tetrix 150 Synergic Plasma
Страница 16: ...Machine description Front view 16 099 007021 EW501 29 07 2015 4 Machine description 4 1 Front view Figure 4 1...
Страница 18: ...Machine description Rear view 18 099 007021 EW501 29 07 2015 4 2 Rear view Figure 4 2...
Страница 32: ...Design and function Plasma welding 32 099 007021 EW501 29 07 2015 Figure 5 7...
Страница 109: ...Appendix B Overview of EWM branches 099 007021 EW501 29 07 2015 109 11 Appendix B 11 1 Overview of EWM branches...
