IONPURE
®
DC POWER CONTROLLER
– IP-POWER600-G2
IP-POWER600-G2 MAN REV. 11
Page 6 of 28
provide a high power factor at most outputs other than at the lowest power levels, which is a result
of the unit’s design as a low bandwidth current source looking into a primarily resistive load. The
power controller has input over-voltage protection as well as heat sink over-temperature protection.
Output over-current protection o
ccurs automatically as a result of the unit’s use as a programmable
current source.
The unit is equipped with cooling fans to provide cooling in an environment with a maximum
ambient temperature of 50 °C. LED indicators provide unit On/Off and Fault status.
The DC output current can be adjusted by any one of following methods:
An optional digital display board, Model No. IP-POWERDSP-G2, which can operate
up to
sixteen
power controllers.
An optional display board, Model No. IP-DSP1 or IP-DSP1P, which can operate
one
power
controller.
An optional display board, Model No. IP-DSP8 or IP-DSP8P, which can operate
up to eight
power controllers.
A 0 to 5 VDC input signal from a remote process controller, such as a PLC.
The power controller output can be turned on and off by a signal from a remote set of contacts.
This feature allows the use of remote instrumentation, such as a flow switch, for turning off
controller output.
A 0 to 5 VDC output signal proportional to the output voltage (8.33 mV = 1 Volt) and 0 to 5 VDC
output signal proportional to the output current range (set through a current range DIP switch) are
available for a remote voltmeter and ammeter to indicate the output voltage and current.
The DC power controller IP-POWER600-G2 carries a CE mark to certify its conformity to the
Electromagnetic Compatibility (EMC) Directive (2004/108/EC) and the Low Voltage Directive
(2006/95/EC).
The DC power controller is a component of the DC power supply used with IONPURE’s CEDI
modules. A complete DC power supply
must
include all of the following:
The DC power controller
An isolation transformer
Circuit protection (fuses or circuit breakers)
Controls and operator interface
The overall dimensions of IP-POWER600-G2 are:
Length: 6.12 in (155.58 mm)
Width: 6.00 in (152.4 mm)
Height: 6.56 in (166.64 mm)
Weight: 6.3 lb (2.9 kg)
A full-size dimensional drawing of the DC power controller unit is included in Appendix C.
