IONPURE
®
DC POWER CONTROLLER
– IP-POWER600-G2
IP-POWER600-G2 MAN REV. 11
Page 10 of 28
The GND terminal of the power controller must be connected to earth
ground (PE) inside the power supply enclosure.
Do NOT install fuses, circuit breakers or any type of switching device
between the DC output of the power controller and the CEDI module.
Doing so might eventually cause damage to the power controller.
Do NOT install a jumper between terminals DC- and GND of the power
controller, nor between the negative and ground terminals of the CEDI
module. Doing so will drive the amplitude of the internal current feedback
sensor and short it, which will damage the power controller. Follow the
wiring guidelines illustrated in Figure 6.
