EVOC EPE-1814V2NAR, Руководство пользователя

Страница: 11 / 58

Chapter 2 Installation
EPE­1814V2NAR ­ 7 ­
Tip: How to identify the first pin of the jumpers and connectors?
1. Observe the letter beside the socket, it would be marked with “1” or thickened
lines or triangular symbols;
2. The square pad on the rear is the first pin;
3. The red line on the cable or other marks show that they should be connected
with the first pin of the socket.
Jumper Setting
JCC1: Clear/Keep CMOS Setting (Pin Distance: 2.54 mm)
CMOS is powered by the button battery on board. Clear CMOS will restore original
settings (factory default). The steps are listed as follows: (1) Turn off the computer
and unplug the power cable; (2) Instantly short circuit JCC1; (3) Turn on the
computer; (4) Follow the hint on screen to enter BIOS setup when starting the
computer, load optimized defaults; (5) Save and exit. Please setup as follows:
JCC1
Setup Function
1­2 Open Normal (Default)
1­2 Short
Clear the contents of CMOS, all BIOS setting will
restore to factory default values.
Audio Connector
AUDIO1
(Pin Distance:
2.54mm)
Pin
Signal Name
Pin
Signal Name
1 LOUT_R 2 LOUT_L
3 GND_AUDIO 4 GND_AUDIO
5 LIN_R 6 LIN_L
7 GND_AUDIO 8 GND_AUDIO
9 MIC_L 10 MIC_R