EVGA Z490 FTW, Руководство пользователя

Страница: 53 / 163

EVGA Z490 FTW (122-CL-E497)
- 53 -
a. For Windows 10: Set “Launch Storage OpROM Policy” to “UEFI”.
Then set “Launch CSM” to “Disable”.
4. Press F10 to save and exit the BIOS/UEFI.
5. Press Del on reboot to reenter BIOS/UEFI.
a. If you are using a SSD-attached via PCIe, proceed to Step 6 .
b. If you are using the motherboard’s M.2 slot, proceed to Step 8 .
6. If you are using an SSD connected via PCIe (e.g. an Intel
®
750) or through an
adapter that connects an M.2 SSD to PCIe , go to “Advanced – PCIe
Configuration” and verify that the device shows on the slot you have it installed.
a. Verify the lane count and PCIe Generation. It should state “x4 Gen3”.
7. Next check the Dashboard on the upper right. The populated slot, lanes used,
and PCIe Generation should all match the information found in the previous
step.
a. Proceed to Step 9 when done.
8. If you are using an SSD connected to the motherboard’s M.2 slot, re -enter the
BIOS/UEFI and go to “Advanced – Onboard Device Configuration, ” and set
“M.2 Socket3” to “Enable . ” The EVGA Z490 FTW auto-enables this option if
an M.2 SSD is detected. However, it is still worth checking to make sure the
option is enabled and/or the device is detected.
9. Go to the “Boot” Section, set “Boot Mode Select” to UEFI, and set first boot
device to “Hard Disk:Windows Boot Manager”.
10. Press F10 to save and exit. Insert/Connect your Operating System install media
and reboot.
11. Begin the Windows installation. During the drive selection step, you may need
to load additional drivers that are provided by the SSD ’ s manufacturer, which
would be covered in the SSD manual. If these steps are not followed you will
likely be unable to install the Operating System to the SSD and make it bootable.