evertz EQT-1616-3G-C, Руководство пользователя

Страница: 15 / 102

EQT-1616-3G-C-C
EQT 12G/3G/HD Router
Page 3
2. INSTALLATION
2.1. UNPACKING
Remove the equipment carefully from the box and look it over. Any error should be reported to your
supplier immediately. Save all the packing material after unpacking the equipment as this could be useful
in the future if it’s needed to return the unit for maintenance.
Check each item supplied for transit damage. Any damage should be reported in detail to your supplier.
You must state the serial number of the unit, which can be found on the rear of the frame. Check that
power cords supplied are suitable for your country and the equipment is compatible with your main (line)
voltage. Note that remote panels are mains powered and must also be checked.
2.2. PHYSICAL INSTALLATION
2.2.1. Router Frames
All units are designed for mounting in standard 19” equipment racks. The depth of the frame is 345mm.
In addition, allowance must be made to accommodate the various cables and connectors that are to be
installed at the rear of the frame.
2.2.2. Remote Panels
Ethernet remote panels are designed to fit into standard 19” equipment racks and can be mounted at any
angle.
2.3. REAR PANEL CONNECTIONS
Figure 2-1 : EQT-1616-3G-C Rear View
2.3.1. Video Inputs & Outputs
I/O ports on the back of the frame consists of HDBNC connectors. The device supports coaxial cable. A
high quality coax cable such as Belden 1694 should be used for optimum performance.
It is both important and good practice that cables are properly supported
and not hanging from the connectors as this can put unnecessary stress
on the connectors and possibly reduces their working life.