evertz 8010TM, Инструкция по эксплуатации

Страница: 84 / 98

Model 8010TM SDI Time Code Master Manual
Page 4-14
Revision 1.5.1
SERIAL PROTOCOL
A6 Sense Generator Run/Hold Returns 1 byte as defined below.
86 Select Generator Run/Hold 1 byte Turns the Generator Hold On and
Off.
00 = Generator Hold
01 = Generator Run
A7 Sense Generator Jam Sync Mode Returns 1 byte as defined below.
87 Select Generator Jam Sync Mode 1 byte Selects the Generator Jam Sync
mode
00 = Generator Free Run (Jam Off)
01 = Continuous Jam Sync
02 = Momentary Jam Sync.

When Continuous Jam Sync mode is enabled, then generator time will be slaved to
the time code from the Reader. The Run/Hold, Drop Frame, and Colour Frame
modes of the generator are determined by the Reader time code. When Continuous
Jam Sync mode is terminated, the formatted Run/Hold, Drop Frame and Colour
Frame modes of the generator are resumed.
A8 Sense Generator No Code Jam Returns 1 byte as defined below.
88 Select Generator No Code Jam 1 byte Determines the behavior of the
Generator when it is in continuous
jam sync mode and there is no
incoming code to the reader.
00 = Hold
01 = Run
02 = Mute
89 Preset Generator Time 4 bytes Presets the time code generator.
This command has no effect when
the generator is in continuous Jam
Sync mode. Expects four bytes of
time data in BCD format as shown
below.
10 Fr 1 Fr 10 Sec 1 sec 10 Min 1 Min 10 Hr 1 Hr
8A Preset Generator User Bit Data 4 bytes Presets the generator user bits.
This command has no effect when
the generator user bits are being
transferred from either the Reader
Time or User Bits. Expects four
bytes of user bit data in DATA
Format as shown below.
UB grp 2 UB grp 1 UB grp 4 UB grp 3 UB grp 6 UB grp 5 UB grp 8 UB grp 7