15
ENGLISH
9.2.6 Hard Positive Temperature cooling with core probe
The temperature hard cooling and preservation cycle consists of the following three phases:
►
Cooling hard phase
►
Cooling
►
Preservation
When a phase is over the control panel automatically switches to the next step.
To start the cycle proceed as follows:
- Make sure the display is in the “ON” mode.
- Make sure the keyboard is not locked and no procedure is currently under process.
►
Press and release the key
(1),
►
press and release the key
(2), then press and rele-
ase the key
(3) so the display will show the icon
and finally press and release the
(4): key until the
icon
is lit on the screen.
IThe display will show the end-of-cooling temperature and the running temperature during the co-
oling phase.
►
Press and release the MENU key, then press and release the key
or the key
key to
select the end-of-cooling temperature and the operating value during the cooling phase, other than
the set ones.
►
Press and release the key
or the key
to change these values then press the ESC key
to store them.
Program: MANUAL
Elapsed time: 0 min
►
Press and release the START / STOP key (1): the test
to verify if the core probe has been inserted properly will
start; see paragraph “Test for checking the core probe
proper insertion”.
►
If the test is completely successful, the cycle starts.
The count of the cooling time limit will start only if the
temperature taken by the core probe is lower than the
fixed temperature.
►
If the test is not successfully completed the buzzer will sound for 5 seconds every 60 seconds
and a time cycle will start; see paragraph “Time hard cooling and preservation”. During the cooling
hard phase the display will show the temperature taken by the core probe, the cell temperature,
the name of the program (if any) and the time elapsed since the starting of the cooling process.
►
Hold the START / STOP key pressed for 3 seconds to stop the cycle.
