Everidge PrepRite PVS27-6-1, Инструкция по эксплуатации, уходу и обслуживанию

Страница: 10 / 26

10
CHAPTER 7
OPERATION
7.1 Control and LCD Display
Description.
To start a sealing cycle, push the main power
switch on (1). Next push the ON/OFF on the
display board (3). Next push the SET button (4)
to enter the program mode, vacuum, seal or gas
option, by using the + or – (5) to select which
mode you wish to use, push SET (4) to select
the program and + or – (5) to increase or
decrease the programs parameters. The cycle
starts when the clear chamber bell-lid is closed,
which will then activate the vacuum pump. VAC
will appear on the display together with the
countdown (in seconds) of vacuum time down to
0 (zero). Should the gas option be activated,
GAS will appear during the cycle, as it will be
injected inside the chamber. Next, sealing will
start as the SEAL appears on the display. At the
end of this process, the cooling of the sealing bar
starts, indicated by the COOLING on the
display. Finally, OPENING will appear on the
display and the clear chamber bell-lid will open
automatically.
NOTE: Should there be a need to interrupt the
cycle for any reason, press the ON/OFF button
(3) for 3 seconds. The appliance will
automatically allow air to enter the chamber and
allow the lid open.
During the normal vacuum cycle, press the
button PUMP GASTRO (6) for 3 seconds to
start heating the sealing bar for manual sealing.
7.1.1 Control and LCD Display 110V
1. Main Power Switch O-I
2. LCD display
3. ON/OFF: to switch on the Control and LCD
display.
4. SET: to enter the program mode (vacuum,
sealing and gas).
5. + or -: to select the desired program and to
increase or decrease the programs
parameters.
6. PUMP GASTRO: to activate the functions of
vacuum in GN trays, pump cleaning and
manual sealing.
7. Vacuum gauge
8. Printer (OPTIONAL)
9. Indicator Lite: indicates power supplied to
the printer and that the printer paper needs
replacing.
10. Button to scroll the printer paper.
7.1.2 Control and LCD Display
Descriptions (double sealing bar)
1. Main Power Switch
2. LCD Display
3. ON/OFF: to switch on the control and LCD
display.
4. Set: to enter the program mode (vacuum,
sealing and gas).
5. + or -: to select the desired program and to
increase or decrease the programs
parameters.
6. PUMP GASTRO: to activate the functions of
vacuum in GN trays, pump cleaning and
manual sealing.
7. Vacuum Gauge.
8. Printer (OPTONAL)).
9. Indicator Lite: indicates power supplied to
the printer and that the printer paper needs
replacing.
10. Button to scroll the printer paper
11. Sealing bar selector knob ( 1 or 2 bars)