EJ_3F012-3F013-3F014-INS-LAB-RevD20 • Traveler L3 Plus User Manual
23
CHECK UPHOLSTERY
Check upholstery at least once a month. Inspect for rips, tears and worn spots. Ensure that
all upholstery-attaching screws are present, properly aligned, and well-secured. Use a Phillips
screwdriver to tighten upholstery mounting screws. Check attaching screws for sharp edges or
stripped screws, and replace if found.
WARNING: Worn or torn upholstery, or upholstery with loose hardware, must be replaced
immediately. It may not support body weight.
CHECK REAR WHEEL ADJUSTMENT
Inspect the wheels at least once a month. Check alignment by elevating the rear of the wheelchair
on a stable object until the rear wheels clear the ground, or placing the wheelchair upside down in
a stable position such that the wheels can spin freely. Spin the wheels; there should be no wobble
or sideplay, and the wheels should spin freely without binding. The bearings should be clean and
rotate smoothly. Check rim sideplay to verify that bearings are not too loose. If there is a problem,
contact your GF authorized distributor. If adjustment is required, this should be done by your
distributor only.
CHECK ARMS
Check arms at least once a month. Inspect for sharp edges or cracks which could weaken the arm,
and replace if found. Ensure all attaching screws are present and tight. Use a Phillips screwdriver
to tighten armpad mounting screws. Check for burrs on the screw heads and replace if found.
Ensure that screws do not extend into the padding. Confirm that posts at base of arm fit correctly
in the sockets, snug but not binding. Adjustable height arms: Confirm fit in the upper telescoping
portion, verify positive locking at each arm height position, and confirm operation of upper arm
release.
CHECK BACKPOSTS / PUSH HANDLES
Check backposts at least once a month. Ensure that all mounting hardware is securely fastened
and that the backposts are not bent or damaged. Contact your GF authorized distributor if you
observe cracking or peeling paint or plating.
CHECK FOOTRESTS & ELEVATING LEGRESTS
Check footrests and legrests at least once a month. Inspect the locking mechanisms to confirm
sure fit. Check for cracks, burrs, or sharp edges, and replace if found. Ensure that the footrest or
legrest will automatically lock securely in place and will not accidentally unlock. If equipped with
heel loops, ensure the anchor bolts are tight and secure.
CLEANING YOUR TRAVELER L3 PLUS
Wipe off the frame frequently, at least once a week, using a soft cloth. Dry the wheelchair
immediately if exposed to moisture. Clean the frame every three months with a mild soap and
water solution. The frame does not need to be waxed. Do not use solvents, abrasive waxes, caustic
chemicals or spray silicone. Never use abrasive cleansers; they could scratch the finish. Never use
steam or high pressure cleaners. Clean upholstery and plastic components at least once a month
with a mild soap and water solution.
