EJ_3F012-3F013-3F014-INS-LAB-RevD20 • Traveler L3 Plus User Manual
15
hinge plate
swingaway
release lever
remove footrest
(left shown)
FRONT RIGGING
FOOTREST—DETACHABLE, SWINGAWAY
WARNING: The footplates' lowest point should be no
closer to the ground than 2
1
/
2
inches, to permit proper
clearance.
WARNING: Do not stand on the footplates; this could
cause the wheelchair to tip.
REMOVE FOOTREST
1. To release lock, pull swingaway release lever forward,
toward front of wheelchair. Footrest will swing outward.
2. To remove, lift footrest straight up off wheelchair hinge
pins.
ATTACH FOOTREST
1. Set footrest on wheelchair (so that footrest hinge plates
engage wheelchair hinge pins).
2. Swing footrest inward.
3. Ensure that swingaway release lever is locked in a
rearward position, toward back of wheelchair.
WARNING: Ensure footrests are locked in place before
occupying or operating wheelchair.
ADJUST FOOTPLATE EXTENSION LENGTH
1. See picture at right.
Loosen latch to free footplate extension inside hanger.
2. Press down on the locking button and adjust the footplate
to the desired length. Ensure that the locking button
is completely extended and securely fastened in the
adjustment hole.
3. Fasten latch to secure footplate extension inside hanger.
4. Repeat steps 1-3 for the other footplate extension.
5. Ensure both footplate extensions are securely fastened and
minimum ground clearance is 2
1
/
2
inches.
WARNING: Ensure footplates are securely fastened
before occupying or operating wheelchair.
footplate
hanger
adjustment
holes
locking
button
latch
footplate extension,
adjust length
