7
THE EVOLUTION OF PORTABLE OUTDOOR COOKING
BARBECUE ASSEMBLY
The barbecue and hood comes pre-assembled in a single package, but a number of components need fitting
to their correct position. Only a medium size Philips screwdriver is needed. For pictures of parts see the parts
lists near the end of this booklet.
UNPACKING THE UNIT
Take the foam covered unit out of the carton, and place on a clean, flat surface. Carefully remove the foam
from each end and take off the protective plastic bag (take care not to kink or damage the hose). Take the
hood and lid handles and fixings out. Remove the lid and remove the parts and packing from inside the
appliance. Do not throw any packaging away until the unit has been completely assembled. Place the
appliance on a stable raised surface, ready for assembly.
FITTING THE CHARCOAL SUPPORT RACK
The charcoal support rack must be placed above the cast iron burner. The loading zone is to be to the top,
biased towards the left hand side. It sits on the supports built into the internal firebox (black enamel) at either
side.
FITTING THE LID HANDLE
Take one handle, the lid, the lid hanging bracket, 2 screws and 2 washers. Place a handle on the top of the
top of the lid (make sure the “Everdure” logo on the handle is aligned with the label at the front of the lid), and
place the lid hanging bracket to the bottom of the lid. Fix together using a Philips screwdriver and the supplied
screws and washers, screwing through the hanging bracket & lid into the handle. Hand tighten both screws so
the handle does not wobble.
7
