User Guide System Mode
36
System Menu Tree
The system mode is divided into five categories [BYPASS], [AUX SWITCH], [MIDI], [GLOBAL],
and [UTILITY] which are the top-level menu items that appear when entering system mode.
In the following, factory default settings are indicated in (bold)
[BYPASS] – Select Bypass Mode
After entering System Mode, turn the Encoder to select [BYPASS], then press the Encoder to
enter Select Bypass Mode. Turn the Encoder to select either [BYPASS TYPE] or [KILLDRY].
[BYPASS TYPE] – Choose Bypass Type
(
DSP
, RELAY, DSP+FX)
Press the Encoder to select. Turn Encoder to select DSP, Relay or DSP+FX.
When [DSP] is selected, Bypass sends the audio at the DSP’s inputs directly to the
outputs without any effects processing.
When [RELAY] is selected, Bypass employs a pair of relays to “hardwire” the inputs
to the outputs, giving a “true bypass.”
When [DSP+FX] is selected, Bypass sends the audio at the DSP’s inputs directly to
the outputs with the decaying ‘tail’ of the current effect mixed in.
Press the Middle Footswitch once to back-up one level to BYPASS menu.
Press the Middle Footswitch twice to go to the top level System menu.
[KILLDRY] – Kill Dry Audio
(NO,
YES
)
Press the Encoder to select. Turn Encoder to enable/disable KILLDRY.
When KILLDRY is enabled (YES), the dry signal is removed from the output and
only outputs a 100% wet level. KILLDRY is normally enabled when
is
connected in your amp’s effects loop. For some of the Presets the Intensity control
acts as a Wet/Dry Mix control. For these Presets, if KILLDRY is YES, the Intensity
control is disabled.
Press the Middle Footswitch once to back-up one level to BYPASS menu.
Press the Middle Footswitch twice to go to the top level System menu.
[AUX SWITCH] – Program Auxiliary Switches
Up to three Auxiliary Switches can be assigned as controls for the Preset
parameters and system control. The three Aux Switches are connected to the rear
panel ¼” stereo phone jack.
detects closures by sensing whether the tip, the
ring or both the tip and ring are grounded. Note that you must use a stereo
phone plug when connecting Aux Switches.
To assign the Aux Switches, first press the Encoder to select AUX SW. You will see
two fields (split display) of the Billboard display (left/right) showing Parameter
destination and Control source assignments. The Left Footswitch LED is flashing (if
it’s not, press the Left Footswitch to select this field) showing this to be the
selected field for editing.
Содержание Space
Страница 2: ......
