Using your full weight press
down on the child restraint (as
shown in step 5) as you tighten
the seat belt.
Then, hold the lap and shoulder
belts together just behind the
free sliding buckle tongue
F
.
Unfasten the seat belt.
Thread the locking clip onto the seat belt, and slide it
into place. Re-buckle the seat belt. Locking clip must
be placed within 1/2” (13 mm) of seat belt buckle.
Locking clip must be placed
within 1/2” (13 mm) of
seat belt buckle.
7
F
Route the vehicle seat belt as shown depending on
your type of seat belt.
Lap & Shoulder
Belt Combination
Lap Belt Only
6
Use a locking clip
E
with lap/shoulder
seat belt combinations that have a
buckle tongue that slides freely along
the belt without locking into place.
If your car does not have this type of
lap/shoulder belt, skip to step 8.
Remove locking clip from vehicle seat belt when not used
with a child restraint or the vehicle seat belt will not properly
restrain an adult or child. Serious injury could occur.
E
You may need to use a locking clip with
some shoulder/lap belt combinations.
WARNING
Installation:
For
ward-facing
25
24
➚
➚
➚
➚
➚
DO NOT
allow the vehicle seat belt release button to
touch the child restraint. Accidental contact may cause
the seat belt to release. If necessary, turn the vehicle seat
belt button away from the child restraint or move the
child restraint to a different location.
D
WARNING
8
Check your work. Make certain the belts are tight. If
you can move the child restraint more than 1 in.
(25 mm) forward or side-to-side at the belt path
D
,
the belts are
not tight enough
. If you have not tightly
secured the child restraint,
try again
or move it to
another location.
DO NOT
use this child restraint if it moves more
than 1 inch (25 mm) forward or side-to-side at the
vehicle belt path. Serious injury or death may result
from poor installation. If you can not tightly secure
the child restraint, try again or move it to
another location.
WARNING
