2
3
1
Remove the playard from the bag. Unhook the two Velcro
®
tabs
C
to remove the mattress pad.
Separate the corners to open the playard.
Note:
Do not push center of the playard floor down yet.
Lift up both long top rails
D
until they securely lock into place with an
audible click.
Note:
The floor
E
must stay up, as shown, so the rails will lock properly.
If the rails do not lock into place, pull up on the loop
F
, draw the feet
together, and try to lock the rails again.
Lift up both short top rails
G
until they lock into place with an audible
click.
2
3
To prevent injury or death,
DO NOT
leave child in product with
SIDES DOWN
.
ALWAYS
make sure sides are raised and
all
four rails
are fully and securely locked by firmly pushing down
on the center of each rail.
SETTING UP THE PLAYARD
Pick up end of playard and push down on the center of the floor
E
until it locks into a flat position.
5
4
SETTING UP THE PLAYARD
6
1
To install the mattress pad:
Place mattress pad
H
on the floor of the playard, cushion side up. Insert
the six mattress straps
I
through the slots
J
in the floor of the playard
and fasten them to the Velcro tabs on the underside of the playard floor.
Make sure all six straps are properly secured to the playard and the Velcro
tabs are facing downward, securing the pad to the playard floor.
Note:
The mattress pad must always be used with the cushion side up.
To avoid injury,
NEVER
use the mattress pad cover
without the mattress pad.
SETTING UP THE BASSINET
IMPORTANT:
NEVER use the playard without the mattress pad securely
installed on either the playard floor or in the bassinet.
Remove child and all accessories from the playard.
To remove the mattress pad
A
,
disconnect three mattress straps
B
from each side of the playard, then remove the pad.
C
E
H
G
E
F
D
G
I
A
WARNING
WARNING
B
Place the mattress pad cover on the mattress pad:
Stretch mattress pad cover over mattress pad and attach four Velcro strips
A
.
Note:
The mattress pad cover is reversible.
A
