EVA Stampaggi ANGLE, Инструкция по эксплуатации

Страница: 50 / 306

03. WARNINGS ISTALLATION
Using coaxial tubes the air will be pre-warmed contributing to improved combustion and lower
emissions into the atmosphere.
Follow the instructions before installing your stove.
Select the position where the stove is to be installed and:

Arrange the connection to the vent pipe for fume extraction
 Arrange the external air intake (combustion air)
 Arrange the connection to the earthed mains

The electrical system of the room where the stove is to be installed must be earthed,
otherwise the control board may not work properly.
 Place the stove on the floor in a convenient position for the connection to the vent pipe
and close to the combustion air intake.
 The appliance must be installed on a floor with an adequate load-bearing capacity.
 Should the existing floor not comply with the requirement above, proper measurements
must be taken (for instance, the installation of a load distribution plate).

All the structures which could catch fire if exposed to excessive heat must be protected.
Floors made from wood or inflammable materials must be protected using non-combustible materials (e.g. 4mm-thick sheet metal or ceramic glass).
 The appliance installation must ensure easy access for cleaning the stove, exhaust pipes and vent pipe.

This appliance is not suitable to be installed on a shared vent pipe.
 During normal operation, the stove draws air from the room where it is installed. Therefore, an external air intake must be positioned at the same height of the
pipe located on the stove back. Exhaust fume pipes must be suitable for pellet stoves and must therefore be made from coated steel or stainless steel, with a
diameter of 8cm and fitted with adequate gaskets.
 The combustion air intake must be connected directly to the outside or to adjacent rooms provided they are fitted with external air supply vents and are not
used as bedrooms or bathrooms or, whenever a fire hazard exists, as storage rooms, garages, combustible material warehouses, etc. The air vents must be
placed in such a way that they cannot be clogged either from the outside or inside and must be protected using a grille, a metal mesh or other suitable means
provided they do not reduce the minimum section.
 If the stove is to be installed in rooms where it is surrounded by combustible materials (e.g. furniture, wood cladding, etc.), the following minimum clearances
must be complied with:
PELLET STOVES and AIR STOVES
COMBUSTABLE NON -FLAMMABLE COMBUSTABLE NON -FLAMMABLE
AIR STOVE 13,5 KW (15) SPC-15 AIR STOVE 13,5 KW (15) SPC-15 AIR-TIGHT STOVES SLIM 7 KW (8) SPE7 AIR-TIGHT STOVES SLIM 7 KW (8) SPE7
REAR WALL P = 120 mm REAR WALL P = 120 mm REAR WALL P = 50 mm REAR WALL P = 50 mm
SIDE WALL L = 300 mm SIDE WALL L = 200 mm SIDE WALL L = 300 mm SIDE WALL L = 200 mm
FLOORING F = - mm FLOORING F = - mm FLOORING F = - mm FLOORING F = - mm
FRONT R = 100 mm FRONT R = 100 mm FRONT R = 1000 mm FRONT R = 1000 mm
AIR STOVE 18 KW (19,5) SPC-19,5 AIR STOVE 18 KW (19,5) SPC-19,5 PELLET STOVES 5 KW (6) SP6 PELLET STOVES 5 KW (6) SP6
REAR WALL P = 120 mm REAR WALL P = 120 mm REAR WALL P = 250 mm REAR WALL P = 250 mm
SIDE WALL L = 300 mm SIDE WALL L = 200 mm SIDE WALL L = 300 mm SIDE WALL L = 200 mm
FLOORING F = - mm FLOORING F = - mm FLOORING F = - mm FLOORING F = - mm
FRONT R = 100 mm FRONT R = 100 mm FRONT R = 1000 mm FRONT R = 1000 mm
AIR STOVE 18,5 KW (20,5) GP-20 AIR STOVE 18,5 KW (20,5) GP-20 PELLET STOVES 8 KW (9) SPCT8 PELLET STOVES 8 KW (9) SPCT8
REAR WALL P = 80 mm REAR WALL P = 80 mm REAR WALL P = 100 mm REAR WALL P = 100 mm
SIDE WALL L = 200 mm SIDE WALL L = 100 mm SIDE WALL L = 250 mm SIDE WALL L = 150 mm
FLOORING F = - mm FLOORING F = - mm FLOORING F = - mm FLOORING F = - mm
FRONT R = 100 mm FRONT R = 100 mm FRONT R = 1000 mm FRONT R = 1000 mm
PELLET KITCHEN 6,7 KW (7,5) CPV-7627 PELLET KITCHEN 6,7 KW (7,5) CPV-7627
PELLET STOVES 7,5 KW (8,6) SPSV PELLET STOVES 7,5 KW (8,6) SPSV
(free-standing installation) (free-standing installation)
REAR WALL P = 10 mm REAR WALL P = 10 mm REAR WALL P = 200
mm
REAR WALL P = 150
mm
SIDE WALL L = 200 mm SIDE WALL L = 100 mm SIDE WALL L = 200 mm SIDE WALL L = 150 mm
FLOORING F = - mm FLOORING F = - mm FLOORING F = - mm FLOORING F = - mm
FRONT R = 1000 mm FRONT R = 1000 mm FRONT R = 1000 mm FRONT R = 1000 mm
PELLET KITCHEN 6,7 KW (7,5) CPV-7627 PELLET KITCHEN 6,7 KW (7,5) CPV-7627
PELLET STOVES 6,5 KW (7,5) SPIN7,5AT PELLET STOVES 6,5 KW (7,5) SPIN7,5AT
(recessed stove) (recessed stove)
REAR WALL P = 10 mm REAR WALL P = 10 mm REAR WALL P =
300-
mm REAR WALL P =
200-
mm
SIDE WALL L = 10 mm SIDE WALL L = 10 mm SIDE WALL L =
150-
mm SIDE WALL L =
100-
mm
FLOORING F = - mm FLOORING F = - mm FLOORING F =
60-
mm FLOORING F =
60-
mm
FRONT R = 1000 mm FRONT R = 1000 mm FRONT R = 1000 mm FRONT R = 1000 mm
PELLET KITCHEN with OVEN 8,6 KW (9,3)
CPF-85
PELLET KITCHEN with OVEN 8,6 KW (9,3)
CPF-85
PELLET STOVES 10,5 KW (12) ANGLE PELLET STOVES 10,5 KW (12) ANGLE
REAR WALL P = 50 mm REAR WALL P = 50 mm REAR WALL P = - mm REAR WALL P = - mm
SIDE WALL L = 50 mm SIDE WALL L = 50 mm SIDE WALL L = - mm SIDE WALL L = - mm
FLOORING F = - mm FLOORING F = - mm FLOORING F = - mm FLOORING F = - mm
FRONT R = 1000 mm FRONT R = 1000 mm FRONT R = 1000 mm FRONT R = 1000 mm