Eurotrac T13-F, Руководство по эксплуатации

Страница: 30 / 81

Page 30/81
April 2021 W11 - W12S -W12F - W13F - T13F | Operation manual
WARNING
Do not loosen or remove the radiator cap while the coolant is hot. Hot coolant under pressure can cause severe
burns.
NOTE
Fuel contamination due to moisture condensing on the inner surfaces of fuel tank can be minimized or eliminated
by keeping the fuel tank as full as possible. The fuel tank must always be filled up at the end of the working day (as
part of the post-operation maintenance routine).
DRIVING INSTRUCTION
• Place shift lever in park.
• Adjust the driver seat and steering wheel to the comfortable location, fasten the seat belt.
• Make sure parking brake is set.
• Verify that nobody and nothing is ahead of you BEFORE starting any motion of the wheel loader.
• Turn ignition switch and engage starter.
• Press the micro-pedal (left pedal).
• Release the parking brake.
• Move the shift lever to the desired position: forward or backward. Press the reset button on the handle.
• Release the micro-pedal and gently press the accelerator pedal, further depress the accelerator until the
required speed is obtained. The micro-loader pedal can be controlled by way of small movements.
• To slow the wheel loader, slowly release the accelerator pedal and press the micro-pedal. For an emergency
stop, release the accelerator pedal and press the micro-pedal. Release the accelerator pedal slowly or quickly,
wheel loader can be braked flat or sharp.
• Each time you park, apply the hand brake, turn off the starter switch to the OFF position and return the
transmission shift lever to Neutral position (the W11 is with foot parking brake).
• While the dual pump is optional on the W13F, the manual triple valve handle must be in the vertical down (OFF)
position before starting. Then press to start normally.
WARNING
The maximum duration of control for an operator should not exceed 6 hours per day.
OFF manual triple valve in a vertical
downward "OFF" position