EUROSTER 2006TXRXG
–
INSTALLATION AND OPERATION MANUAL
7
CONNECTING FLOOR SENSOR
a)
Check if the J1 jumper is in the floor position (point 4.4.)
b)
Connect the floor sensor to terminals 4 and 5 of the thermostat.
c)
Reset the thermostat.
d)
The thermostat operates according to the floor sensor temperature read-out. The
temperature control range increases to 45°C. The standard temperature sensor is
inactive.
7.
RXG RECEIVER SETTINGS
ESTABLISHING CONNECTION BETWEEN 2006TX THERMOSTAT AND RXG RECEIVER
OR RECEIVERS (PAIRING)
Each thermostat and each receiver has a unique number that distinguishes it from others. It is
not possible for any thermostat not paired with the particular receiver to interfere with the
operation of another pair or set.
The thermostat may be paired with other receivers at any time. A blackout, battery
replacement as well as a complete reset of all thermostat settings do not affect the pairing of
devices in any way.
Pairing procedure:
•
Press the RESET button on the thermostat (under the front flap)
•
Remove the thermostat cover
•
Press the button on the transmitter board three times, the LED starts flashing in red
and green alternately
•
Insert the RX receiver into the mains socket
•
Press the pairing button (E) on the receiver 3 times
–
the blue LED lights up
•
When the connection is established, the blue LED on the receiver goes out
•
If you use only one receiver, press the button on the transmitter board, the light goes
out. The pairing mode is ended.
If you are going to pair multiple receivers (maximum 6), proceed as follows:
•
When the first receiver is detected
•
Insert the second receiver into a mains socket
•
Press the button on the receiver 3 times
–
the blue LED lights up
•
When the receiver is detected, the blue led goes out
•
Proceed similarly with the connection of the subsequent receivers, then press the
button on the transmitter board. The pairing mode is ended.
Caution! Pairing mode is only available for 10 minutes after connecting the receiver
to the mains and resetting or installing batteries in the thermostat!
Factory-established thermostat
–
receiver pairs are paired, however, pairing may be
repeated if necessary.
SELECTING OPERATING MODE
Press and hold the pairing button (E) on the receiver for approximately 5 seconds.
Depending on the mode set, the green or red LED lights up. Each time the button is pressed,
the operating mode changes. When you select the mode, the receiver restores operation.