EUROSTER 2006TXRXG
–
INSTALLATION AND OPERATION MANUAL
3
4.
RXG RECEIVER VISIBLE ELEMENTS
A.
On/off
switch
for
continuous operation of
the heating device
B.
Power converter socket
C.
Output cable
D.
Two-color LED
E.
Button used to pair and
change settings.
5.
INSTALLATION
SAFETY RULES
CAUTION!
•
Prior to the commencement of any installation works read this manual
carefully! Incorrect installation and improper use may lead to serious hazards
to users or other persons and result in property damage!
•
Prior to mounting or dismantling the set make sure that the heating/cooling
system is de-energized!
•
Voltages hazardous to life may be present on receiver output cables (power
supply phase voltage), therefore only qualified technicians may install the
thermostat!
•
The electric connections performed and cables used shall be adequate to the
applied loads and must conform to all requirements!
•
Do not install the set in rooms with increased humidity; protect it against
water and other liquids!
•
Do not install any unit showing signs of mechanical damage!
•
The thermostat is not a safety component. Additional protection devices must
be used in systems prone to the risk of damage due to the failure of control
systems!
•
The device is not intended for use by children!
•
Should there be any problem with the proper operation of the thermostat,
please contact your technician or the manufacturer!
PROPER PLACE OF INSTALLATION
The thermostat is designed for indoor installation. No cables are connected to the thermostat,
thus it can be placed anywhere. To ensure fully efficient operation of the thermostat, please
make sure that the following recommendations regarding the location of the thermostat are
observed:
•
Locate the thermostat at the height of approximately 1.5 m above the floor
•
Avoid places with strong sunlight, near heating or cooling devices, situated directly by
doors, windows, and other similar locations, where the temperature measurement could
be easily disturbed by external conditions.
•
Avoid places with poor air circulation, e.g. behind furniture.
•
Avoid moist places due to the negative effect of moisture on the service life of the
device.