SigNET 200/300 User Guide
8
ELAB 1543
3. Press the right menu key to restore the alert. The message ALL ALERTS RESTORED displays and
the flashing Alert LED turns off.
For system or communications type alert conditions (Mains failure or E-BUS disconnect), locate the source of
the alert condition and check that all wires and cables are properly connected.
For a tamper alert, ensure the lids on all enclosures and devices are correctly closed. If the physical fault
cannot be restored to its normal operating state, contact the installation engineer. The alarm system still
operates by either inhibiting or isolating the fault condition.
3.8 Coded
Restore
The coded restore option is only available if the Security Grade of the system is set to Grade 3 or Engineer
Configure. It provides the user with the ability to restore alert conditions that would normally only be
available to the installation engineer. To provide the user with this ability, it is necessary to protect this
feature with a code.
To perform a coded restore on the system:
1. Ensure that the zone or fault that caused the alert condition has been physically restored to
its normal operating state.
2. Contact the installer or the alarm receiving centre (ARC) before entering user programming
and selecting the coded restore feature in the menus option. (Contact details should be
available from the drop down label beneath the Keypad.)
3. Press SELECT on the Coded Restore option. A 6-digit reset code displays on the top line.
4. Provide 6-digit code to installer/ARC.
5. Receive newly generated code from installer/ARC.
6. Enter new code at the AUTH CODE prompt.
7. Press
SELECT.
The message SYSTEM RESTORED displays on the top line of the display.
3.9
Using 868MHz Wireless Fob
If an 868MHz wireless receiver module (Fob) is installed and configured on the Keypad or Controller and the
user profile is configured for device and respective settings, the SigNET system enables functionality using a
868 MHz wireless fob. An authorised installation engineer configures the device and its settings, and users
are instructed for activation of the device for the following commands:
•
Set/Unset
•
Partset
•
Clear
Alerts/Restore
•
X10
Functionality
3.10 Using a Portable ACE
If a PACE reader is installed and configured on the SigNET Keypad, it is functional only with users of PACE-
configured profiles.
If a Limited User’s profile is configured for such device and functionality, once presented within 1cm of the
Keypad’s receiver area, the PACE enables setting and unsetting denoted by the usual set/unset beeps.
Note
An Alert condition only displays on the Keypad when the system is UNSET. If the system is SET
when an alert condition occurs, the Keypad gives no indication of that alert condition until such
time as the system is UNSET.
Note
The coded restore feature can only be operated from the Keypad. It is not accessible from the
browser.
Note
Force setting with the RF fob
: It is NOT possible to forceset the system with an RF fob even if the
user assigned to the fob has the ability to forceset. Force setting is only possible at the Keypad.
