SigNET 200/300 User Guide
6
ELAB 1543
3. Setting, Unsetting, and Restoring the System
The following functions are available to users by entering a user code; these
functions do not require menu navigation on the Keypad. User codes
comprise 4, 5, or 6 digits, depending upon the programming grade of the
system.
A user’s permission rights, i.e. ability to see menus and options available on
the SigNET 200/300 system, are programmed by the installation engineer. If
users cannot see options described in this manual, they do not have rights to
access such functionality.
When a code is entered, the digits display as asterixes and the left function
key displays the QUIT option. This is for security reasons, so codes are not
visible when entered.
After entering a code, the following options are presented: FULLSET,
PARTSET A, PARTSET B, MENUS. Scroll these options by using the
up/down arrow keys. An ellipsis (…) on accompanying graphics denotes
when there is a choice of menu selection by scrolling.
3.1
Setting the System: FULLSET
The FULLSET option provides the following functionality:
•
Full protection to a building (opening of alarm zones activates alarm)
•
Opening of entry/exit zones starts the entry timer. If the alarm is not
unset before the entry timer expires, the alarm is activated
To select the FULLSET option, enter a valid user code, and press SELECT
(right soft key). The second line displays the exit time and the buzzer sounds
to indicate that the user should exit the building. When the system has been
fully set, the LCD displays FULLSET on the bottom line for approximately 10
seconds.
If the alarm fails to set, see Section 3.4, Failing to Set the System.
3.2
Setting the System: PARTSET A
The PARTSET A option provides the following functionality:
•
Perimeter protection to a building while allowing free movement
through the exit and access areas
•
Exclusion of EXCLUDE A zones from protection
•
Instant activation of alarm on selection of mode; by default there are
no exit times associated with PARTSET A
To select PARTSET A, enter a valid user code, scroll to the PARTSET A
option and press SELECT (right soft key).
If the alarm fails to set, see Section 3.4, Failing to Set the System.
3.3
Setting the System: PARTSET B
The PARTSET B option provides the following functionality:
•
Perimeter protection to a building while allowing free movement
through the exit and access areas
•
Exclusion of EXCLUDE B zones from protection
•
Instant activation of alarm on selection of mode; by default there are
no exit times associated with PARTSET B
To select PARTSET B, enter a valid user code, scroll to the PARTSET B
option and press SELECT (right soft key).
Note
Partset A and Partset B configuration modes are dependent upon how the system has been
programmed.
…FULLSET?...
EXIT
SELECT
…PARTSET A?...
EXIT
SELECT
…PARTSET B?...
EXIT
SELECT
…MENUS…
EXIT
SELECT
…FULLSET?...
EXIT
SELECT
18/04/2008 12:30
SETTING 45 SECONDS
18/04/2008 12:30
SYSTEM FULLSET
…PARTSET A?...
EXIT
SELECT
18/04/2008 12:54
PARTSET A SET
…PARTSET B?...
EXIT
SELECT
18/04/2008 12:55
PARTSET B SET
