![Eurolux EIH6 TC3B FV Скачать руководство пользователя страница 98](http://html.mh-extra.com/html/eurolux/eih6-tc3b-fv/eih6-tc3b-fv_installation-manual_2438779098.webp)
98
EN
When the timer has run down, a signal
will sound, the timer display will show
“
00
” and the assigned cooking zone
timer LED will blink. The programmed
cooking zone will switch o
ff
and “
H
” will
be displayed if the cooking zone is hot.
The sound signal and the blinking of the
timer LED will stop automatically after 2
minutes and/or by pressing any button.
Buzzer
While the hob is in operation, the
following activities will be signalled by
the buzzer.
• Normal button activation will be
accompanied with a short sound
signal.
• Continuous button operation over a
longer period of time (10 seconds)
will be accompanied with a longer,
intermittent sound signal.
Boost Function
To use this function, select a cooking
zone and set the desired cooking level,
then press the “P” (Boost) button.
The Boost function can only be activated
if it is applicable with the cooking zone
selected. If the Boost Function is active,
a “
P
” will be shown on the corresponding
display.
Activating the booster can exceed the
maximum power, in which case the
integrated power management will be
activated.
The necessary power reduction is
shown by the corresponding cooking
zone display blinking. Blinking will be
active for 3 seconds to allow for further
adaptations ofthe settings before power
reduction.
Special Cooking Modes (available
only for the model EIH6 TC3B FV)
Press and release the heater selection
button to cycle through the boiling,
frying, keep-warm and chocolate-
melting special cooking functions.
Special cooking functions are only
available on the right side of the hob.
Boiling and frying cannot be selected
simultaneously until after one beep is
heard from the hob.
Boiling Function
This function is used to boil water and
keep the temperature close to boiling
point. To activate the boiling function,
press the heater selection button twice.
When the boiling function has been
activated, the corresponding display will
show “b”. The hob will beep to indicate
when the water has boiled and the water
will then simmer.
The above image shows the front right
heater display indicating the boiling
function.
Frying Function
This function will fry oil at around 160°C.
To activate this function, press the heater
selection button three times. When the
frying function has been activated, the
corresponding display will show “
F
”.The
hob will beep when the oil is ready for
frying.