00112264.DOCX, Version 1.1
23/28
Interconnecting several devices (master/slave operation)
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller.
The devices must be set to the corresponding
operating modes.
1 Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
2 Set all devices to the same DMX address (page 24).
3 Configure the master unit by pressing the
MENU
button so many times until
SLMD
is indicated in the
display. Confirm with the
ENTER
button and use the buttons
UP
and
DOWN
to select the
MASt
setting.
Confirm with the
ENTER
button.
3 The configure all slave units by pressing the
MENU
button so many times until
SLMD
is indicated in the
display. Confirm with the
ENTER
button and use the buttons
UP
and
DOWN
to select the
SLAu
setting.
Confirm with the
ENTER
button.
4 Set the master unit to the desired show program. The interconnected devices will now operate in sync.
Remote control IR-26
When actuating a button, always direct the remote control towards the sensor. There must be no obstacles
between remote control and the sensor. In DMX and slave mode, the IR remote control is deactivated.
Button
Function
Stand By
LEDs off
DMX
DMX operation
Show 1-7
Show program 1-7
Running speed selection with Speed >
Speed +/Speed ‒
LED Color
Color selection for the LEDs
LED Random
Random color selection for the LEDs
Laser
Laser beams on/off
Laser Color
Color selection for the laser beams
LED Random
Random color selection for the laser beams
Sound ON
Sound control on
Sound OFF
Sound control off
Speed +
Program running speed up
Speed ‒
Program running speed down
Speed
Medium program running speed
Notes:
•
The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the
foil from the battery support on the rear side of the remote control. Otherwise operation of the remote
control is not possible.
•
If the range of the remote control decreases, replace the battery. For this purpose,
on the rear side of the remote control press the small bar with the groove to the
right and at the same time remove the battery support. For operation, one 3 V
button cell type CR 2025 is required. When inserting, pay attention that the
positive pole of the button cell shows upwards in the support.
•
Remove the battery from the remote control as a precaution if the device is not used for a longer period of
time.
