©
EUROHEAT
DISTRIBUTORS (H.B.S) LTD.Aug 2006
Instructions Part number IN1016 Ed G
9
Changing Flue Outlet Direction
Remove flue spigot.
Remove flue outlet blanking plate.
Refit flue spigot using gasket as a seal.
Refit flue blanking plate.
Fit the half moon blanking plate in the
recess of the top plate using the fitting
bracket.
Gas Connection
a)
Connect the gas supply pipe to the 13mm connection at the rear of the appliance.
b)
Connect a suitable gas pressure gauge to the test nipple, turn the gas supply on and check
that the gas connections are sound. If satisfactory light the appliance. Check all the gas connections
on the appliance for leaks. The appliance is factory tested, but it is possible for a connection to have
been disturbed during transportation and installation.
c)
Set the control to the high setting, and check that the gas pressure is as stated on the data
table.
d)
Turn off the gas, remove the pressure gauge and refit the test point screw, turn the gas supply
on and check that test nipple is gas sound.
