Eurogames Srl – Operation and maintenance handbook – BUMPER CAR & MINI BUMPER CAR
23
[PROG]:
This button enable or disable the programming mode.
ATTENTION
Enter programming mode only when the machine is not in use. Using the remote control to check
or alter parameter settings while the machine is in use may result in incorrect configurations and
anomalous functioning.
Display description
In the display there are some useful information: The internal software
version, “BAT=” battery charge value, “Device Selected:” Selected
product for next command transmission, “LastCommand=” last sent
command information.
EG09 Digital Timer Configuration – “ALL” devices
To setup all the device together the “ALL” option must be selected.
Press [PROG] button to enable the programming mode. The display
shown the configuration parameters. The [+] and [-] buttons select the
required parameter and the [SEL] button enable the editing mode. In
the editing mode a black blinking cursor is shown. The value can be
changed by [+] and [-] buttons.
The new value is sent to the device when the [SEL] button is pressed
again to exit editing mode. Please note that all the powered products
in the transmission range will receive the new parameter configuration.
Below you can find an example list of parameters that can be changed by the remote control unit when
“ALL” option is selected. Important: the available parameters may be different due to a possible
software update without notice (for more information please check the EG09 Digital Timer
Configuration).
Game-Time, Game-Coins, Coin-Mode, Volume, Speed-High, Speed-Low, Auto-Brake, End-
Brake,EndBrakeDelay, TelBrakeDelay, End-Sensor, EndSensTime, Acceleration, Deceleration, Low-
Battery, Free Coins, Max Speed, EndGame Stop.
EG09 Digital Timer Configuration – Single device
To setup a single device its specific number must be selected as “Device Selected” option. Press
[PROG] button to enable the programming mode. In this case the remote control unit receive the
configuration parameter value directly from the selected EG09 Digital Timer included in the product. In
the “Single” configuration mode all the configuration parameters included in the EG09 Digital Timer can
be changed.
The [+] and [-] buttons select the required parameter and the [SEL] button enable the editing mode. In
the editing mode a black blinking cursor is shown. The value can be changed by [+] and [-] buttons. The
new value is sent immediately to the device. Press [SEL] button to exit editing mode.
If the remote control unit detect no transmission message from the device a “* No Signal *” message is
shown in the display. In this case check the power and the device number.
