Euresys EureCard Grablink Series, Руководство пользователя

Страница: 55 / 74

GRABLINK series Installation Instructions
55
GRABLINK series Installation Instructions
Hardware installation procedure for Grablink Value,
Grablink Avenue and Grablink Expert 2
Grablink Value, Grablink Avenue and Grablink Expert 2 are PCI add-on boards. Before
operation, they must be physically inserted in an available PCI slot of your computer.
Grablink Value, Grablink Avenue and Grablink Expert 2 need no hardware setup adjustment
(switch or jumper).
Multiple Euresys boards can be hosted in the same computer, as long as slots are available.
Recommended installation procedure:
1. Switch-off the computer and all connected peripherals (monitor, printer...).
2. Discharge any static electricity that could be accumulated on your body. You can
achieve this by touching an unpainted metal part of the enclosure of your computer with
a bare hand. Make sure that the computer is linked to the AC power outlet with proper
earth connection.
3. Disconnect all cables from your computer, including AC power.
4. Open the computer enclosure to gain access to the PCI slots according to the
manufacturer instructions.
5. Locate an available PCI slot and remove the blank bracket associated with this location.
To achieve this, remove the securing screw and keep it aside for later use in the
procedure. Keep the blank bracket in a known place for possible re-use.
6. Unwrap the Grablink packing, take the board and carefully hold it. Avoid any contact of
the board with unnecessary items, including your clothes.
7. Gently insert the board in the targeted PCI slot, taking care to push it down fully into the
slot. If you experience some resistance, remove the board and repeat the operation.
You should attempt to make a perfect board-to-slot mechanical alignment for best
results. Ensure that the lower part of the bracket is inserted into the corresponding
enclosure fastening.
8. Secure the board with the saved screw.
9. For Grablink Expert 2, optionally install the auxiliary board (see following pages).
10. Close the computer enclosure according to the manufacturer instructions.
11. Establish the camera connection (see following pages).