Euresys EureCard Grablink Series, Руководство пользователя

Страница: 50 / 74

GRABLINK Expert 2 cPCI Description
50
Bracket layout
The bracket attached to Grablink Expert 2 cPCI
provides four connectors.
The upper connector is for system connection, such as
external trigger, illumination control or motion encoder.
It is a sub-D 9-pin female connector.
This connector is called
SYSTEM .
A red/green pair of LEDs called Status LEDs shows
the global status of the frame grabber. When the
green LED is lighting (ON), MultiCam is correctly
started. If the red LED is lighting (ON), that is a board-
wide error has appeared.
The second connector is for general purpose
Input/Output connection. It is a sub-D 25-pin female
connector.
It is called
I/O .
The two bottom connectors are for camera connection.
They are blade contact high-density 26-pin female
connectors. They comply with the Camera Link
standard.
The upper connector is called
CAMERA t B , while the
lower one is called CAMERA t A .
Grablink Expert 2 cPCI fully supports the Base and
Medium configurations as per the standard. Refer to
the following table:
Connector
Base
configuration
Medium configuration
Camera A
Used by first
camera
Primary
Camera B
Used by
second camera
Used by
single
camera
Secondary
Two red/green pairs of LEDs called LEDs for
CAMERA B and LEDs for CAMERA A , placed above
the concerned connector, give information about each
camera acquisition. The green LED is lighting (ON)
during expose and readout phases of a sequence. If
the red LED is lighting (ON), that is a channel
acquisition error has appeared during the sequence.
In depth information is available in the electronic
documentation coming with Euresys products.
Grablink manuals are parts of Euresys MultiCam
documentation.