15
Operation: Enable the keep watch function to set the idle time and the number of the called preset point
and save them, the longest idle waiting time can be set to 99999 seconds, but should not be commonly set is
too long.
Note:
1) all PTZ control functions need to camera RS485 ports baud rate, the agreement, address and other
information set to the same as the PTZ decoder board Settings can be controlled, please refer to this manual
4.1.2 RS485 parameter Settings;
2) to avoid parameter is missing, please set all the parameters in and then click the “save Settings” button in the
top right corner interface, to save the parameters.
4.1.7. Image Modes
Fig. 26.
Click “Image mode” label at the right to set up the video parameters under certain circumstances (E.g.
daylight, strong light, and night light, etc.) These modes can set up different start time and stop time, and can
automatically adjust to match the latitude and longitude of where the camera is installed.
Image mode setting:
Daytime mode, strong light mode, dawn mode and night mode. Each mode can set to
be a corresponding time range. Each mode can set up different video parameters according to the current
circumstance so as to reach the best image effect.
Longitude and latitude setting:
If enabling the image mode, the system shall provide the longitude and
latitude setting of the device installation position. After setting up the longitude and latitude of the device
installation as well as the initial start time and stop time of the image mode, the system shall automatically
calculate the start and stop time of the image mode every day based on the longitude and latitude.
Note:
In the time-phased setting, if the start time of two modes overlaps, the mode gets started according to the
order of the modes, subject to the last mode. If the parameters above are modified, please go to the page of
Advanced settings” to click “Save settings” button. Otherwise, all the modified parameters shall be lost after the
power is disconnected. Please refer to “Saving settings”.
