Settings of the ETL Interface
Instruction Manual ATS 400 with SC-NG
Version 4.03
48
10
Settings of the ETL Interface
The settings can be on factory or using
ETL DataView 3
. In
ETL DataView 3
you
find the dialog from the main menu under
Settings
->
I/O-Interface
. Grayed out
elements are for information only and are related to the equipment of the device.
The settings for an external control and the tones can be configured independently
for the pass and failed case.
Closing the dialog with the button
Back
will save the settings. Closing the dialog with
the button
Menu
the settings will not be saved. The settings are stored in the
ATS400.
The time diagrams for the different settings are valid using
ETL DataView 3
. Using
your own application by controlling with the DLL or LabVIEW the the function
ETLKWPTestResult must be used to generate the signal
Ready for Operation
. By
controlling with the ASCII-protocoll the whole commanding is done using the
interface.
In the case a test plan consists of several test steps the signals
In Operation
and
Ready for Operation
will change there state for each test step.
It is only the start signal as start condition displayed. This must be used in the test
plan as start condition. Other signals can be used by
ETL DataView 3
. For the
following diagrams these signals are considered as set. Using the setting
then security curcuit must be used as start condition instead of start signal.
10.1
Standard setting
This setting is factory default. There will be not output on the ETL interface and no
tones.
