10
VII.Programming Tips/Trouble shooting
The Programmer Displays
“Programming Error”
If the Programmer and MNPR™ are
powered improperly or if the optical cable is mounted improperly, the Programmer
will display,
“Programming Error”
. If you see this message make sure the
Programmer and MNPR™ are powered in the proper sequence. In addition, make
sure the optical connector is securely mounted on front of the MNPR™ with the word
Top facing up.
Pressing buttons
1, 4
at the same time will reset the Programmer. If the
Programmer and MNPR™ were powered out of order and the
“Programming Error”
message appears, try resetting the Programmer to see if that clears the error.
VIII.Technical Support
The ETI MNPR™ and Programmer are rugged units meant to be used in harsh
conditions. Nonetheless, they are not indestructible. Do not drop, throw or
submerge the Programmer (the MNPR™ is fully submersible). With a minimum of
care, the Programmer should have a long life span.
Technical help for both the ETI MNPR™ and the MNPR™ Programmer is available
from the following sources:
Richards Manufacturing Co. Sales, Inc.
Electronic Technology Inc,
517
Lyons
Avenue
511
Lyons
Avenue
Irvington,
NJ
07111
Irvington,
NJ
07111
(973)
371-1771
(973)
371-5160
FAX
(973)
371-4304 FAX
(973)
371-1929
