Eternal GU125T, Инструкция по установке и эксплуатации, Страница: 30 / 39

Condensate Piping
Temperature Setting Procedure
30
Hot Water Stored Temperature Setting:Normal(125 ˚ F), Hotter(145 ˚ F), High output(165 ˚ F)
Loosen hand wheel screw, Iift hand wheel, turn to desired temperature as indicated on the front display the hand
wheel and retighten screw.
It is possible to limit the temperature range 70 ° F~145 ° F using this feature.
Tempering Valve Adjustment
•
Tempering Valve Adjustment
•
Loosen screw, lift hand wheel.
1.
Turn hand wheel clockwise or counter clockwise to adjust temperature.
2.
Reposition hand wheel tolock postition.
3.
Retighten screw. 4.
1
2
2
3 3
4
1
Water Temperature above 120 ˚ F can cause serious injury. Mixing valve temperature settings should be done by a
licensed contractor per local requirements. To ensure correct temperature control, use water thermometer at faucet
outlet.
□
WARNING
!
!
It is recommended once a year, the sring inside the tempering valve to be relaxed, to ensure proper temperature
delivered.
Contact a licensed professional for maintenance.
NOTICE
! !
Once the unit has been properly installed, check the gas and water connections for leaks.
Check for proper ventilation and combustible air supply to the water heater. Purge the gas and water lines to
remove debris; then follow these steps to turn on your unit.
Close the manual gas shut-off valve located on the gas line.
Fully open the manual water shut-off valve on the water supply line.
To ensure complete
 lling of the tank, allow air to exit by opening the nearest hot water faucet. Allow water to
run until a constant  ow is obtained. This will let air out of the water heater and piping.
Open a hot water tap to check that water will  ow to that tap. Then close the hot water tap.
Fully open the manual shut-off gas valve.
Plug in the 120 VAC/60Hz power supply to the water heater and turn on the unit.
□
□
Starting Up
1.
2.
3.
4.
5.
6.
Never use this hot water heater unless it is completely  lled with water.
The tank must be  lled with water. Water must  ow from the hot water faucet before turning "ON" gas to the
water heater.
□
CAUTION
! !
Operating Instructions