Operation
7
Operation
WARNING:
Connect this equipment to a non-dimmable power source in
order to avoid damage to the equipment's internal power supply and other
electrical components. Using a dimmable power source may damage the
equipment and will void the warranty.
These instructions guide you through the general operation of the SealerAtor IP tester.
•
See
Onboard User Interface on page 9
for detailed information about the onboard
user interface and navigation controls.
•
See
for detailed information about using the PC software.
Tools and parts needed:
•
3.0 mm hex key
•
Adjustable wrench
•
Flatblade screwdriver
•
Air hose (provided with the SealerAtor)
•
Power cable (provided with the SealerAtor)
•
One threaded bolt (provided with the SealerAtor)
•
One rubber washer (provided with the SealerAtor)
•
One microSD card (provided with the SealerAtor, or any microSD card 8 GB or larger)
Note:
Inspect the rubber washer before use, and replace the washer if it is damaged
or brittle.
Connect the SealerAtor to the Fixture
1. Remove the back cover from the fixture.
a. Disconnect power to the fixture.
b. Use a 3.0 mm hex key to remove the six screws that secure the back cover to the fixture.
c. Detach the safety cable from the fixture.
d. Remove the cover.
