ETC ArcSystem Pro One-Cell, Руководство по установке, Страница: 9 / 29

ETC Installation Guide
Pro One-Cell
Pro One-Cell Page 9 of 29 ETC
Wire and Terminal Specifications
Terminal/Connector
Conduit
Entry
Wire Range/Specifications
Strip
Length
Torque Rating
D1 power input
line/neutral/ground ½ in
conduit
Up to 6 mm
2
(10 AWG) solid or stranded
7 mm
(1/4 in) 0.8 Nm
(7 in-lb)
D1 HOand D2 power input
line/neutral
½ in
conduit
0.5–10 mm
2
(22–6 AWG)
7 mm
(1/4 in) 0.5 Nm
(4.4 in-lb)
D4 maintained power input
line/neutral
D4 emergency drivers
sense power input
line/neutral/ground
½ in
conduit
0.2–2.5 mm
2
(24–14 AWG)
6.5 mm
(1/4 in) 0.5–0.6 Nm
(4.4–5.3 in-lb)
Power Input
ground ½ in
conduit
2.5–10 mm
2
(6–14 AWG)
10 mm
(3/8 in) 4.0 Nm
(35 in-lb)
DMX In/Thru
RJ45 Connectors ½ in
conduit
Cat5e (or better) minimum 0.2 mm
2
(24 AWG) conductors terminated to
T568B standard
N/A N/A
Outputs for all D1, D2, and
D4 Series Drivers with Molex
connectors
½ in
conduit
Follow Class 2 wiring methods.
Outputs for D4 drivers with
terminals ½ in
conduit
0.2–2.5 mm
2
(26–14 AWG) using the
provided two-terminal connectors.
Follow Class 1 wiring methods.
6 mm
(1/4 in) 0.4–0.5 Nm
(3.5–4.4 in-lb)
Note:
Maximum supported wire length between One-Cell luminaires and D1 Series and
D2 Series drivers is 15 m (49 ft).
Maximum supported wire length between any load and a D4 Series driver is 10 m (33 ft).
Mounting the Driver
Depending on your installation, you might want to surface-mount the driver. Any ArcSystem
standalone driver can be surface-mounted to any surface capable of supporting its weight using the
four holes located on the back side of the enclosure. Contact ETC for custom mounting bracket
options.
1. Remove the two screws on the cover of the driver and set them aside.
2. Remove the driver cover. The cover is tethered to the backbox. Be careful when handling.
Note:
If you are installing a D1 High Output driver, the power supply is inside the cover
and has wiring that runs to the driver board in the back panel of the driver. Be careful when
handling. It may help to nest the back panel of the driver inside the cover as shown in
Wiring the Driver and Luminaire on page 12 .
3. Using four #10 screws, mount the back panel to the mounting surface.
4. Attach flexible conduit to the driver. There are four conduit knockouts available.
5. Install Romex or nonmetallic screw-clamp conduit connectors to output knockouts, as needed.