ETC Installation Guide
Pro One-Cell
Pro One-Cell
Page 26 of 29
ETC
Maintenance
WARNING:
RISK OF DEATH BY ELECTRIC SHOCK! Failure to disconnect all
power to the system before installation, maintenance, cleaning, or any other
system modification could result in serious injury or death.
AVERTISSEMENT :
RISQUE DE MORT PAR DÉCHARGE ÉLECTRIQUE! Négliger
de débrancher toutes les sources d’alimentation du système avant l’installation,
l’entretien, le nettoyage ou toute autre modification du système peut causer
des blessures graves ou la mort.
De-energize main feed to ArcSystem and follow appropriate Lockout/Tagout
procedures as mandated by NFPA 70E. It is important to note that electrical
equipment such as breaker panels can present an arc flash hazard if improperly
serviced. This is due to the high amounts of short-circuit current available on
the electrical supply to this equipment. Any work must comply with OSHA Safe
Working Practices.
WARNING:
Disconnect the fixture from power and DMX and allow it to cool
before performing any cleaning and maintenance.
AVERTISSEMENT :
Débrancher la lampe de son alimentation et du DMX et
la laisser refroidir avant d’effectuer un nettoyage ou un entretien.
WARNING:
Circuits that are installed without an accessible power disconnect
device cannot be serviced or operated safely.
AVERTISSEMENT :
Il est imprudent d'utiliser ou de réparer les circuits
installés sans qu'un dispositif de déconnexion de l'alimentation ne soit
accessible.
CAUTION:
Check for excessive dust or debris in the heat-dissipating fins around
the entire luminaire enclosure. Clean using compressed air or a soft cloth.
Keeping the components of the enclosure clean facilitates efficient cooling and
extends LED longevity.
NEVER spray liquids into the luminaire.
NEVER spray compressed air into a luminaire that is powered-up.
Note:
The light source(s) contained within ArcSystem luminaires shall only be replaced by
the manufacturer or his service agent or a similar qualified person.
A can of compressed air or oil-free air from an air compressor set at a low setting can be used to
blow through the vent holes and remove dust or other debris. Dust buildup can cause overheating
and premature shutdown.
All components can be cleaned using compressed, oil-free air as described above or a clean micro-
fiber cloth. The use of any liquid cleaning solution is not recommended.
Inspect all mounting hardware for wear and, if necessary, clean using compressed, oil-free air or a
soft, lint-free cloth.