eta Mole E3, Руководство по эксплуатации

Страница: 14 / 32

14 www.eta.co.at
Installation
Loosen about 4 cm from the copper strand at this end
of the pellet hose. Bend the copper wire inwards to
make contact between the pellet hose and the mole.
Then push the pellet hose onto the suction tube of the
mole.
Fig. 4-10: Sliding the pellet hose onto the suction pipe
Attach the cable reel from the lifting module with the
hose clamp to the suction tube.
Fig. 4-11: Fitting the cable reel
Check if the side opening on the suction tube is free. If
not, attach the pellet hose slightly higher.
Fig. 4-12: Checking the opening
Connect the plug from the electric wire to the mole
connector.
Fastening the spring pulls to the pellet hose
Attach the spring pulls to the pellet hose with the
detachable cable ties (only hand-tight).