eta Mole E3, Руководство по эксплуатации

Страница: 12 / 32

12 www.eta.co.at
Installation
4 Installation
Assembly and installation only by qualified
specialist personnel
The assembly and installation may be performed
by specialist personnel with the corresponding
qualifications only.
Pay attention to the detailed plan
If there is a detailed plan, the positions of the spring
pulls, wall feedthrough, etc. must be observed. This is
so smooth operation can take place later. If there is no
plan, the planning instructions must be observed; see
chapter
3 "Information for planning" .
Mounting the wall bracket
The exact mounting position for the wall bracket is
given in their custom plan. Holes or an opening in the
wall to the pellet store are required for the pellet hoses
and electrical lines. If these are not yet available, use
the wall bracket as a template for marking.
Fig. 4-1: Wall mount
Instead of individual holes, you can also have an
opening of about 220 x 80 mm.
Hold the wall bracket against the wall and check that it
is level. For an uneven wall, the support surface must
be adjusted accordingly. Apply fire protection acrylate
(not included in delivery) to the wall bracket all the way
around so it completely seals with the wall.
Fig. 4-2: Wall bracket sealing
Mount the wall bracket with suitable screws on the
wall.
Fig. 4-3: Mounting the wall bracket
Attach the hose clamp for the pellet hose to the wall
bracket.
Fig. 4-4: Hose clamp