eta GRATUSSINO Bravo, Инструкция по эксплуатации

Страница: 54 / 104

Safety hints and tips
– Do not let the blender running without any food!
– Do not remove the knife support G2 from the glass container!
– Never use the glass blender without the lid G1 .
– Never pour boiling liquids in the container.
– Before removing the blender lid or container, wait until the rotating parts completely stop.
– When the blender is in the state of idle operation, e.g. the blade fails to touch the foods,
unplug the unit until the foods have been relaxed.
Before the first use
We recommend washing the glass container before using it for the first time. The knife
section is treated with oil not harmful to health for technological reasons. Therefore first
fill in the container with warm water (max. 50 °C) with a small amount of detergent. Then
put the container on the food processor, set the maximum rotational speed and run for 1
minute. Then rinse the container with clear water.
Use
Remove the lid, put or pour the food into the container and replace the lid. We recommend
that you always switch on the blender to minimum revolutions and then gradually increase
the performance as required.
The recommended processing speed is
1 to MAX .
Tips
– Never fill the container with liquids producing foam (for example milk) up to „ MAX “ level
to prevent overspill. We recommend 1 litre at maximum.
III.7 Poppy seed grinder (H)
Description
(Fig. 13)
H1 – Feeder (assembled) H4 – Pressure disc
H2 – Cover with hopper H5 – Regulating disc
H3 – Grinding discs (2 units) H6 – Key (=Q9)
Safety hints and tips
– Never tighten the grinding discs by force!
– Poppy seed grinder is exclusively designed to process poppy seeds! Do not process
other food (such as cereals, flax and sesame seeds, corn, rice, buckwheat, dried mushrooms,
herbs, spices and coffee, etc.). Never process wet, damp or frozen poppy seeds!
– Never adjust the grinding coarseness level when the motor unit is running!
Assembly
Assemble the poppy seed grinder and attach it to the motor unit head according to
Fig. 13 and Fig. 7. Put the „fixed“ grinding disc H3 on the feeder, slowly rotate it until three
arresting projections of the disc click into three recesses of the feeder.
Then put the „mobile“ grinding disc (with the grooves lining up) on the fixed grinding disc.
Put the pressure disc H4 on the shaft so that the central projection is aligned with the
grinding disc opening. Then rotate the pressure disc until three arresting projections of the
disc click into three recesses of the feeder. Finally put on the regulating knob and tighten it.
54
GB
/ 97