18
Assembly (Cont.)
Step 5: Installing the Reflectors and Bell
1. Remove the clamp screw from the reflector (or bell) bracket.
2. Push open the bracket “loop” and slide it onto the handlebar. (If there is a sizing
insert included with the bracket, please be sure it is inside the clamp loop before
mounting.)
3. Position the bell bracket (Fig. 24) or the reflector bracket (Fig. 25) at a certain
position on the handlebar and tighten the clamp screws securely.
CAUTION!
• Be sure the reflector is in the same longitudinal plane as the bicycle
(horizontal to the ground). If the reflector is aimed up or down, oncoming
headlights may not reflect properly in the reflector. If the reflector is not
horizontal to the ground, loosen the clamp screw and readjust the angle.
• It is important to check and adjust the position of the reflectors as you
assemble your bike. The reflectors must always be vertical (perpendicular to
the ground) and pointed toward the front and rear of the bike.
Rear reflector (red)
1. Put the mounted rear reflector
in the correct position by
loosening the screws of the rear
reflector bracket (Fig. 26), before
attaching the red reflector (Fig.
27).
2. Make sure the rear reflector is
vertical to the ground and points
straight back.
Fig. 24
Fig. 25
Fig. 26
Fig. 27
18
AUS
AFTER SALES SUPPORT
MODEL: EST-EMTB275 PRODUCT CODE: 706076 11/2021
1300 112 534
tempo.org/support
