Estate Swing E-SC 400, Инструкция по эксплуатации

Страница: 25 / 37

E-SC 400 / 402 Classic Series Instruction Manual
Power
The Estate Swing E - SC 400 comes with 1) 24V transformer. The transformer supplied has 2 screw terminals to
connect to. You may locate the transformer up to 200’ away from the control board using 16 gauge, 2 conductor
stranded direct burial low voltage wire. Do not use solid core wire.
Allow a minimum of 4’ of wire from the transformer to the control board.
Insert the two wires from the transformer into the two TRAN terminals on the control board. The wires are not
polarized, there is no positive or negative.
DO NOT SPLICE THE POWER CABLE WIRE .
!
Never run 110VAC power directly to the Estate Swing.
This will destroy the Estate Swing control board. Never connect the power wire
with the transformer plugged in. Contact between the two lead wires, even for a
second, will destroy the transformer. Transformers are only warranted if the inter-
nal fuse is not blown. If the fuse is blown an outside factor (shorting, surge, wa-
ter, etc.) has caused the transformer not to function.
12V DC 12V DC
-
- _
+
_
+
Transformer
Plug the transformer into a 110 V AC outlet.
The transformer is not weather proof and must be kept in a covered area. Plug covers are available from your
dealer, contact 1
- 800 - 640 - GATE for a dealer in your area.
Two 12V DC batteries (Max 5 a/h per battery) may be run in series as backup to the 24V transformer power.
Running two 12V batteries in series creates a 24V system, you cannot run them in parallel (see diagram above)
When you install new batteries - manually open the gate and allow the batteries to charge for 12 hours through the
system before using the gate opener.
3.6