EST LSRA, Инструкция по установке, эксплуатации и обслуживанию

Страница: 55 / 92

Programming
message segment window (lower window). Press ENTER to enter the
message and automatically position the cursor back at the zone
window, ready to select the next zone. Press the UP arrow key to step
to the next higher zone, or press the DOWN arrow key to step to the
next lower zone, and repeat the process for all active zones.
If a message is already available for a zone, it will appear for editing
when the zone is selected. The total number of zone messages entered
is shown on the screen along with an arbitrary number for each
message. This number shows the message’s position in a file, and may
change when the file is automatically sorted when the message entry
screen is saved to a file.
The XFER function is not available to transfer messages between
annunciators having different sub-addresses in the LSS4 mode.
Editing Tools
A number of editing options have been provided to assist in rapidly
entering message text. The Transfer (
X FER) function may be used to
copy the information from a previously configured panel into the
"selected display,” when using the FCC configuration. The message
stack may be used to rapidly manipulate message text.
Using the XFER (Transfer) Function
(FCC mode only)
When all information and messages have been entered for the selected
LSRA, press ESC until the
"Parameter Entry for Entire Project" menu
appears. Press S to move the cursor to the Select Display window.
Enter the address of the
next LSRA display to be configured in the
selected display window. To copy a configuration from a previously
configured display into the “selected display,” press X to move the
cursor to the XFER (transfer) window. Use the UP and DOWN arrow
keys until the address of the
source display's address appears in the
XFER window. Press ENTER to start the transfer process. Press Y to
confirm the transfer. The selected display is now configured identically
to the source panel, and ready for any required editing.
Using the Message Stack
A second editing function called the temporary message stack may be
used to modify the contents of the message window. The message stack
window is located immediately below the two message window
segments. The message stack is used to speed up the process of editing
and entering messages in the selected LSRA. Once a message has been
entered into the message window, a copy may be sent
down to the top
of the stack by pressing CTRL+D. The addition of a message to the
message stack pushes all previously saved messages lower on the
stack. The stack can hold up to four different messages. The message at
the
top of the stack can be copied back up into the message window by
pressing CTRL+U. If the stack message to be copied into the message
window is not at the top of the stack, rotate the stack by pressing
CTRL+R until the desired message reaches the top of the stack, then
LSRA
Installation, Operation, Maintenance, and Configuration Manual 4.19
firealarmresources.com