EST LSRA, Инструкция по установке, эксплуатации и обслуживанию

Страница: 53 / 92

Programming
• PC Communications P ort: Press the UP and Down arrow keys, or
key the number directly, until the desired PC serial port number for
download/upload appears in the window.
Detailed parameter specifications may be found in the Parameter
Descriptions and Specifications section of this chapter.
A full list of keyboard commands appears in the Keyboard Commands
section of this chapter.
When all required parameters have been entered in the “Parameters for
Entire Project” menu, press the TAB key to save the previous entries
and step to the “Parameter Entry for Selected Display” menu.
Phase 2 -Parameter Entry for Selected Display
After the network environment parameters have been entered, each
LSRA(-C) must be configured (phase 2). The “Parameter Entry for
Selected Display” screen is the first of two screens used to configure
each LSRA (phase 2), and enter its messages (phase 3).
WED FEB 6, 1994 11:16:35 Remote Alpha-Numeric Display Network
PARAMETER ENTRY for SELECTED DISPLAY
Current Project File: Selected Display: 1 LSS
Project Name: Printer: NONE
Screen Label: Baud Rate: 9600
Annunciation Type(s): Alarm + Super Trouble Routing: All Messages
Active When Enabled:
Active When Disabled:
L Enter Screen Label P Select Printer
A Select Annunciation Type(s) B Select Comm Baud Rate
E Select Active When Keyswitch Enabled R Select Routing of Mess
D Select Active when Keyswitch Disabled T Transmit to Display
N Set to No Switch Panel H Print Hard Copy (or File)
INSTRUCTIONS
Press letters R, A, L, E, D, or B to alter the corresponding item.
Press letters N, T, or H to execute the action stated.
Press TAB to move to the next screen and enter or edit messages.
The Selections shown Above will be saved.
Press ESC to return to prior menu-Selections shown will be saved.
LSS4 Selected Display Menu
1 Verify that the address of the desired annunciator appears in the
"Select Display" window. Normally the annunciators are configured
in order, starting with #1. If the desired screen is not displayed,
press ESC to return to the prior window, then press S and enter the
correct display number. Press ENTER then TAB to return to the
second screen.
Note:
All information displayed on this screen applies to the LSRA(-C)
whose address is displayed in the
Selected Display
box.
2 Enter the required annunciator information for the parameters
listed below. Key in up to 12 characters for the screen label. Press
ENTER to accept the screen label or ESC key to abort and retain
the prior location. Press A to select Annunciation type(s). Use the
UP and DOWN arrow keys to select from the available options
shown in the window.
Screen Label
Annunciation Type(s)
LSRA
Installation, Operation, Maintenance, and Configuration Manual 4.17
firealarmresources.com