The fan and generator drive belt must be kept at sufficient tension to prevent slippage on the pulleys. Do not adjust too
tightly or rapid wear on fan and generator bearings will result. To adjust belt tension, loosen nut "A" and swing
generator away from engine to tighten. Then lock adjustment by thoroughly tightening nut "A."
Clutch Pedal
The clutch rod length should be adjusted so that the clutch pedal can be pushed down 1-1/2" before the clearance is
taken up between the levers on the clutch cross shaft and the clutch throwout yoke shaft and further movement of the
clutch pedal will begin to disengage the clutch.
[Pg 11]
