Use only a mixture composed of 1/2 kerosene and 1/2 engine oil. Turn starter shaft with wrench, moving wrench handle
toward the engine until plug "A" is accessible through opening in rear engine plate. Remove plug "A," continue turning
flywheel until opening is down and all clutch oil is drained. Then turn until opening is again accessible. Pour in by means
of offset funnel no more than 1/3 pint of clutch mixture. Replace plug "A" and tighten securely. The clutch oil should be
drained and replenished at least every 5000 miles.
The clutch throwout bearing should be lubricated with one ounce of light viscous grease
every 500 miles. A pressure
fitting is provided on the right side of the clutch bell housing.
See page 7 for grease specifications.
Transmission
[A]
[Pg 6]
