Installation
Care@Home™ Pro System Installation Guide
25
b.
Check the list of troubleshooting solutions. Refer to 6 Troubleshooting on page 30.
c.
Contact professional services or technical support for assistance.
3.8.
Ending Installation
The installation process is complete when you:
Test the Care@Home
™
Pro system. Refer to 3.6 Testing Peripheral Installation on page 21.
Deactivate the CP installation mode. Refer to 3.7.1 Deactivate Installation Mode on page 25.
Close the CP. Refer to 3.7.2 Close the CP on page 25.
3.8.1
Deactivate Installation Mode
You must deactivate the CP installation mode before the CP can begin normal operation mode.
To deactivate the installation mode:
1.
Locate the
TEST
pinhole on the back of the CP, as shown in Figure 5 on page 17.
2.
Insert the open end of a paperclip or a probe into the pinhole, as shown in Figure 5 on page 17.
3.
Push the paper clip or probe in the
TEST
pinhole until you feel a click. The CP announces
“Installation test ends.”
3.8.2
Close the CP
Replace the back cover of the CP according to the instructions in
Installation
in the ESUGSC003
Care@Home
™
CP User Guide.
