Installation
Care@Home™ Pro System Installation Guide
21
3.5.
Installing Peripherals
The following is the procedure to install the Care@Home
™
peripherals, pre-configured to
communicate with the installed CP.
Essence recommends you install the peripherals in the following sequence:
1.
Install a magnetic sensor (MGLS) on the refrigerator door.
2.
Install an MGLS on the front door.
3.
Install a motion detector (PIR) in the bedroom.
4.
Install a PIR in the restroom (toilet room).
5.
Install a PIR in the bathroom.
6.
Install a PIR in the living room.
7.
Install a PIR in the dining room.
8.
Install additional activity peripherals (PIR and MGLS) as determined during the planning stage.
Perform each peripheral installation according to the following general installation procedure:
1.
Insert the batteries in the peripheral. When CP recognizes the peripheral, the CP installation mode
program gives a prompt to verify correct placement and that detection is working.
2.
Secure the peripheral in its pre-determined location, using either double-side adhesive mounting-
tape (recommended) or screws and wall anchors (if preferred).
3.
Test the peripheral installation. Refer to 3.6 Testing Peripheral Installation on page 21.
For installation instructions and details for each of the activity peripherals, refer to the user guide for
that specific peripheral. For an index of the user guides, refer to 5 Care@Home™ Documentation on
page 29. You can access the guides at:
http://www.essence-grp.com/resources/smart-care-
download.html
3.6.
Installing the Active Service
Before installing the
Active
service, ensure the resident's smartphone meets the following
requirements:
Apple: iOS 9.0 or later
Android
™
: OS 4 or later
Minimum mobile screen size of 4.7”
1.
If the resident has the
Active
service, download the
Active
app from the Apple® App Store or the
™
Play Store and install it on the resident's smartphone.
2.
Ensure Bluetooth is enabled.
3.
If the resident’s phone is a
Xiaomi
:
