Escea KS1150 Peninsula 400, Инструкция по установке и обслуживанию, Страница: 33 / 52

B
A
C
D
E
F
G
SER
VICE
33
F
Finishing the Installation
F1 Coal, Crystallite, or Driftwood Fuelbed Installation
If using the crystalight, coal, or driftwood fuel beds, first place all the crystallite/coal pieces in a single
layer atop the burners and fuelbed tray. Cover the entire area except for the pilot shield, ensuring
coverage right up to all glass windows and rear of firebox for single sided.
If the driftwood fuelbed style has been chosen, follow the above directions for placing the crystallite
and then place the driftwood pieces randomly atop the crystallite layer. Ensure the wood pieces are
evenly spread out and do not cover the pilot assembly.
Do not heap or mound any fuelbed.
F2 Log and Woodland Log Fuelbed Retainer Setup
When setting up a log or woodland log fuel bed, you must have the correct retainers present before
assembling the fuel bed. The correct retainers are supplied with the fuel bed packaging.
First remove the infill by following section E4. On the
UNDERSIDE
of the infill you will see numbers
1 to 4 (see left image below). On your retainers you will see a number and a letter, the number is used
to match with the infill and the letter is fuelbed type i.e. W = Woodland, L = Logs.
Fold ALL the retainer tabs 90° away from you when reading the number and letter on the top face
(above right). Assemble all retainers by feeding the tabs, from the
UNDERSIDE (unpainted side)
through the cutouts on the infill and fix in place with screws provided (see below). Replace the infill and
burners in the fireplace.
Only for the log fuelbed: the final log retainers are placed on TOP of the infill and burners to support
the end log (number 2 from index). This part comes in flat form and is to be folded as per the images
below.
Top Face