Escea KS1150 Peninsula 400, Инструкция по установке и обслуживанию, Страница: 24 / 52

B
A
C
D
E
F
G
SER
VICE
24
E
Installing the Appliance
E1 Connecting the Flue
Access the top of the appliance and connect both the inlet flue (Ø75mm
ID/85mm OD) and the exhaust flue (Ø100mm ID/110mm OD) to their
respective spigots. Tighten the hose clamps onto the spigots. Ensure the
flue connection is air tight. Sealant is not required.
E2 Installation
Insert the gas fire into the
cavity and fix the appliance
down in the correct position
using the brackets on each
end of the appliance.
It is a requirement that
this appliance be securely
fastened at the base.
E3 Removing (and Replacing) the Glass
Remove the glass by unscrewing the four 1/4 turn fasteners located at the top of the glass (shown in
the diagram below) and remove the bracket (shown below shaded grey). Attach the provided suction
cups and use them to handle the glass. Slide the glass away from the non-glass end. Allow the glass to
lean towards you and carefully lift it out .
WARNING: The flue connection MUST be secured with the
clips provided and tape MUST NOT BE USED. If any of the
flue pipe is damaged and integrity compromised then it should
not be repaired with tape, it should be replaced.
Use the brackets that
were affixing the fire
to the pallet for
securing the fire in
place once installed.