5.
Lay Table Top (#1) painted side down, on a smooth, flat surface. Use the shipping
container to protect the painted surface of table top.
6.
Align the ”U” Support (#21) on Table Top (#1) as shown in
Figure 5
.
7.
Align all four holes in each U-Clip (#22) with the four Indentations in table top. Be sure that Slot
in the Three U-Clips (#22) all face the same direction toward the end of the table with no stripe
and no Indentations. Secure U-Clips (#22) with Screws (#5) as shown in
Figure 5
&
Detail A
.
Note:
All four holes in the U-Clip (#22) must align with four Indentations in table top. See
Detail A
.
Note:
All Indentations
guides in table top are
small so look closely.
Note:
End with no stripe
and no Indentations.
5
Figure
8.
Rotate U-support (#21) that is on bottom of Table Top
until you see the screw holes in the slots of U-clips (#22).
If necessary Slide U-support (#21) side to side and back
and forth to see holes. See
Figure 5
&
Detail B
.
9.
Insert Screw (#35) through slot in U-clip (#22) and into U-support
(#21). See
Figure 5
&
Detail B
. Thread screw all the way into U-
support until it touches the back of the tube. There should be about
3/8” of screw (#35) left sticking out. Repeat for second Screw (#35)
and U Clip (#22).
Note:
To aid in assembly you can use a cordless drill and
Phillips bit.
Wear safety glasses
.
Or
Scan with your smartphone:
Detail A
21
22
35
1
5
21
22
Slot in
U-Clip
1
Detail B
35
#8-32 X 1 1/4
Sheet Metal Screw
(Qty. 2)
5
HARDWARE NEEDED
#8 X 9/16 Screw
(Qty. 12)
If you want to see a video on how to insert Screw (#35) go to:
http://www.escaladesports.com/customer-service/instruction-videos
WHEN ASSEMBLING TABLE, IT IS EXTREMELY IMPORTANT THAT THE U-CLIPS (#22) BE TURNED
AS SHOWN HERE. IF U-CLIPS ARE TURNED INCORRECTLY, YOU WILL DO IRREPARABLE DAMAGE
TO YOUR TABLE WHEN YOU ATTEMPT TO OPEN IT TO THE PLAYING POSITION.
IF USING AN ELECTRIC SCREWDRIVER PLEASE SET AT LOW TORQUE AND USE CAUTION
BECAUSE YOU COULD OVER-TIGHTEN THE HARDWARE AND STRIP SCREW IN WOOD
DOING IRREPARABLE DAMAGE TO THE TABLE. DO NOT OVER TIGHTEN SCREWS!
8
NOTICE
NOTICE
